|Publication ahead of print|
|Published online||25 September 2020|
The analytical approach of Drone use in radiation monitoring
Nuclear Protection Department, National Institute for Nuclear, Chemical and Biological Protection,
Milín, Czech Republic
2 Department of Geological Sciences, Faculty of Science, Masaryk University, Kotlářská 2, 60200 Brno, Czech Republic
* Corresponding author: firstname.lastname@example.org
Accepted: 18 August 2020
During the traditional way of radiation field monitoring − walking measurements – is possible to encounter inaccessible or dangerous areas. For this case, the National Institute for Nuclear, Chemical and Biological Protection (SUJCHBO) has created the method of aerial measurement of ambient dose equivalent rate (ADER) using the drone equipped with gamma-spectrometer. This paper presents two methods on estimation of near-surface gamma radiation based on aerial measurements with Drone equipped with gamma-spectrometer D230A. The D230A was first tested in a room fitted with walls with a higher amount of natural radionuclides from uranium series. The aerial measurements were done at SUJCHBO’s Heliport at three altitudes (6, 11 and 16 m) and from the obtained data, the values of ADER for the altitude of 1 m were calculated and compared with the data measured in the altitude of 1 m. From the two proposed methods, the first one serves for evaluation of the whole measured area while the second method serves for evaluation of zones of interest. In the case of the first method, the highest difference between the calculated and measured data for the altitude of 1 m was 20% and, in case of the second method, the difference of −13.3% and −8.2% was achieved.
Key words: radiation / monitoring / drone / aerial measurement / ADER
© SFRP, 2020
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.